Advantages of our technology:

• No tool wear;

• No thermal or mechanical influence on surface layer structure of machined workpiece (machining temperature range 18…50ºC);

• Technological result does not depend on hardness or strength of machined materials. No direct mechanical contact between tool and workpiece;

• Machined surface has not changed layer (structure, chemical composition);

• No burrs or rough edges;

• Technological liquid implied is a low concentration water solution of nontoxic and uninflammable mineral salts;

• Low voltages implied (5-20 V) Fine surface finish is archived at a high machining rate. Electrode tool may be made of easy to machine conductive materials (brass, copper);

• Deviation of dimension in one group of machined parts usually less than 10 um